CD
Activity overview
Latest activity by CD
-
CD created an article,
How to Install D6+ Steering Damper
We will begin by removing the two front deck screws. Then, attach the base plate using the two m6 bolts provided. Tighten down with a 5mm allen key. Once this is done, it is time to install t...
- CD
- Updated
- 2 followers
- 1 comment
- 1 vote
-
CD created an article,
How to Install a Speed Controller on a NANROBOT D4+ 2.0
The steps required to replace a speed controller are very similar across all NANROBOT scooter models. This video shows the process on a D6+, though it is nearly identical to the steps taken on a D4...
- CD
- Updated
- 3 followers
- 1 comment
- 0 votes
-
CD created an article,
Adjusting Suspension on a D4+2.0
The D4+2.0 suspension can only be adjusted in the rear, though it is a relatively simple process. Here is a video highlighting the general process of adjusting the ride height of a coil shock for t...
- CD
- Updated
- 1 follower
- 0 comments
- 0 votes
-
CD created an article,
Adjusting Disc Brakes on a NANROBOT D4+ 2.0
The brake adjustment for all NANROBOT D4+ 2.0 scooters is nearly identical to the process shown in this video: The key differences between the scooter shown in the video (D6+) and the D4+2.0 is ...
- CD
- Updated
- 1 follower
- 0 comments
- 0 votes
-
CD created an article,
How to Tighten Handlebars on a D4+2.0
Loose handlebars are an easy fix on the D4+. There is a small screw (2.5mm drive) located in the hinge of the handlebar: Begin by sliding the collar out, and folding the handlebar into the lower...
- CD
- Updated
- 2 followers
- 1 comment
- 0 votes
-
CD created an article,
How to Tighten D4+2.0 Stem
The stem on a D4+2.0 is adjustable in several ways. The first way to tighten down the stem is to adjust the 10mm tension nut that is located on the underside of the folding mechanism: The key ...
- CD
- Updated
- 2 followers
- 0 comments
- 0 votes
-
CD created an article,
How to Change a Flat Tire on D4+ 2.0, D4+ 3.0, D6+ and RS7 Scooters
The process for changing a flat tire is essentially the same across all NANROBOT scooter models. The key differences will be where/how the motor wire is attached to the swing arms. Please note that...
- CD
- Updated
- 1 follower
- 0 comments
- -1 votes
-
CD created an article,
Removing Griptape and Decklid
Removing the decklid and grip tape on the NANROBOT D4+ 2.0 is exactly the same process as the D6+, though the shape of the decklid is slightly different. In either case, it is necessary to remove t...
- CD
- Updated
- 1 follower
- 0 comments
- 0 votes
<%= heading %>